SUPERGRIP® ANTI-SLIP SPRAY

SUPERGRIP^® ANTI-SLIP SPRAY

•  Light duty anti-slip finish
•  Adheres to metal, wood, concrete, tile floors and parquet
• Also ideal for tools
•  Very quick drying (5-10 minutes)

This topcoat makes every surface Non-skid in a second. SuperGrip™ Anti-Slip sprays are based on a fast drying acrylic modified short oil alkyd. The coloured products are based on lead- and chromate free pigments and contain a special anti-slip additive. Should be applied on metal, concrete, ceramic and wood surfaces or properly prepared painted substrates.

DESCRIPTION This topcoat makes every surface Non-skid in a second. SuperGrip™ Anti-Slip sprays are based on a fast drying acrylic modified short oil alkyd. The coloured products are based on lead- and chromate free pigments and contain a special anti-slip additive. Should be applied on metal, concrete, ceramic and wood surfaces or properly prepared painted substrates.

RECOMMENDED USE RUST-OLEUM Anti-Slip 2400 should be applied on metal, concrete, ceramic and wood surfaces or properly prepared painted substrates. Steel should be primed with 2169 or 2182.

RUST-OLEUM Anti-Slip 2400 are intended for small maintenance jobs or for touchup. RUST-OLEUM Anti-Slip 2400 should be used interior/exterior in light industrial exposures where anti slip characteristics are required.

DRY TIMES BY 20º C/RH 50% Touch dry: 20 minutes Dry to handle: 60 minutes Dry to recoat: after 1 hour with itself Fully cured: 7 days

RECOMMENDED WET FILM THICKNESS 100 µm

RECOMMENDED DRY FILM THICKNESS 25 µm

THEORETICAL CONSUMPTION 2,5 m² per spray can at 25 µm dry

PRACTICAL CONSUMPTION Practical coverage depends on many factors such as porosity and roughness of the substrate and material losses during application.

SURFACE PREPARATION Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. Sand intact coatings to provide a proper key for adhesion. The surface must be clean and dry during application

APPLICATION CONDITIONS For good results the relative humidity shall be below 85% and the temperature of the can and substrate above 10°C.

APPLICATION & THINNING: AEROSOL Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use. Hold the can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to achieve adequate coating thickness. After use turn can upside down and press spray buttonfor 2 - 3 seconds to clean valve.

REMARKS Not for use in wet areas such as bathrooms or on substrates which are regularly in contact with water.

Made by: