Rust Oleum Leak Seal Flexible rubber coating 500ml

Rust Oleum Leak Seal Flexible rubber coating 500ml

• Watertight semi smooth finish
• Can be top-coated with latex or oil-based paints
• For use on metal, aluminum, PVC, concrete, masonry, asphalt roofing materials, etc.
• Overcoatable with various paints

DESCRIPTION

Designed to fill and seal leaks and cracks on metal, aluminium, galvanized metal, PVC, concrete, masonry, asphalt/bituminous roofing materials, vinyl siding, fiberglass, and more.

RECOMMENDED USE

Designed to fill and seal leaks and cracks on metal, aluminium, galvanized metal, PVC, concrete, masonry, asphalt/bituminous roofing materials, vinyl siding, fiberglass, and more.

DRY TIMES BY 20º C/RV 50%

• Touch dry: 20 - 30 minutes
• Dry to handle: 45 - 60 minutes
• Dry to recoat: Apply second layer LeakSeal after 15 - 30 minutes.
• Top-coated with water-based or oil-based paints after 24 hours.
• Fully cured: 24 hours

RECOMMENDED DRY FILM THICKNESS – 65 μm

THEORETICAL CONSUMPTION – 0,74 m² per aerosol at 65 μm dry film thickness

PRACTICAL CONSUMPTION – Practical coverage depends on many factors such as porosity and roughness of the substrate, size of the leakage and material losses during application.

SURFACE PREPARATION

Remove all dirt and debris from the area to be coated. Wash area with a detergent and water solution, rinse with fresh water, and allow the surface to dry thoroughly. Remove any loose paint or previous coatings with a wire brush or sandpaper. Lightly sand glossy surfaces. Wipe the sanded surface clean when finished. Test previous coated material for compatibility before use.

APPLICATION CONDITIONS

Use outdoors or in a well-ventilated area such as an open garage. Apply when temperature is between 50ºF and 90ºF (10 - 32ºC) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200ºF (93ºC). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

APPLICATION & THINNING:

Shake aerosol vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum for technical support. A test spray on cardboard is recommended to obtain feel for the spray pattern. Hold the aerosol 8-18” (20 - 45 centimetre) from the surface and spray in short even strokes. It is recommended to apply a light first coat. Apply a second heavier coat to ensure proper coverage. A thicker film can be achieved by moving the nozzle closer to the surface. Initial spray may have some foaming or bubbling, but will dissipate as the coating dries. For best results, apply 2 coats. Allow to dry 15- 30 minutes between coats.

SHELF LIFE – Minimum of 2 years from date of production in unopened cans, if stored in dry, well ventilated areas, not in direct sunlight at temperatures between 5° and 35°C. If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.

• Wipe off tip when finished.
• Clean-up wet paint with xylene or mineral spirits.
• Properly discard empty container.
• Do not burn or place in home trash compactor.

Made by: